SAE J1122_200410

SAE J1122_200410

Click here to purchase
The following SAE Recommended Practice furnishes sample forms for helical compression, extension and torsion springs to provide a uniform method for specifying design information. It is not necessary to fill in all the data, but sufficient information must be supplied to fully describe the part and to satisfy the requirements of its application. For detailed information, see “Design and Application of Helical and Spiral Springs – SAE HS 795”, also “Helical Compression and Extension Spring Terminology – SAE J1121”. Both of these documents use SI (metric) Units in accordance with the provisions of SAE TSB 003, as does SAE J1122. Here, however, the U.S. Customary Units (in, lb, psi) have been added in parentheses after each SI Unit for the convenience of the user who must furnish specifications on a project where all requirements are listed in non-metric terms.

Product Details

Published:
10/11/2004
File Size:
1 file , 180 KB

You may also like

SAE J2862_202305

SAE J2862_202305

User’s Manual for the Small Adult Female Hybrid III Test Dummy (Stabilized: May 2023)standard by SAE International, 05/22/2023

SAE AS22520/48A

SAE AS22520/48A

CRIMP TOOLS, TYPE 1, HAND OR POWER ACTUATED, WIRE TERMINATION, HYDRAULIC TOOL FOR WIRE BARREL SIZES 0000 THROUGH 8standard by...

SAE AS4832B

SAE AS4832B

Gland Design: Nominal 3/8 Inch Cross Section for Compression-Type Sealsstandard by SAE International, 06/12/2023

SAE AS7477J

SAE AS7477J

Bolts and Screws, Steel, UNS S66286 Tensile Strength 130 ksi, Procurement Specificationstandard by SAE International, 08/01/2023

Back to Top