SAE J485 specifies the recommended nominal diameters and locations of holes in bolt or screw shanks, and nominal widths and depths of slots in nuts, for use with the recommended sizes of inch-series cotter pins, as shown in Table 1.
User’s Manual for the Small Adult Female Hybrid III Test Dummy (Stabilized: May 2023)standard by SAE International, 05/22/2023
CRIMP TOOLS, TYPE 1, HAND OR POWER ACTUATED, WIRE TERMINATION, HYDRAULIC TOOL FOR WIRE BARREL SIZES 0000 THROUGH 8standard by...
Gland Design: Nominal 3/8 Inch Cross Section for Compression-Type Sealsstandard by SAE International, 06/12/2023
Bolts and Screws, Steel, UNS S66286 Tensile Strength 130 ksi, Procurement Specificationstandard by SAE International, 08/01/2023